[Coladam] Question about ADAM I/O map

Geoff Oltmans geoff at oltmansfamily.org
Sun Feb 14 04:00:34 CET 2010


Could you maybe make your device IO base address relocatable? There isn't really a lot of third party hardware out there, and likely not all combinations are usable at once.

On Feb 13, 2010, at 6:45 PM, Eduardo Mello wrote:

> Thanks Geoff. So from your list the only free spots are 50h~53h...
> That is bad, I need an extra spot and none is available.
> 
> Eduardo
> 
> On Sat, Feb 13, 2010 at 7:07 PM, Geoff Oltmans <geoff at oltmansfamily.org> wrote:
>> I sent him one... but here's the copy I got long ago...
>> 
>> 
>> 
>> On Feb 13, 2010, at 6:05 PM, Rich Drushel wrote:
>> 
>>> 
>>> On Sat, February 13, 2010 4:54 pm, Eduardo Mello wrote:
>>> 
>>>> Is there any known ADAM device that uses I/O ports 40h and 60h~63h?
>>> 
>>>    The Orphanware parallel printer interface uses port 40H.
>>> 
>>>    I don't believe anything used 60H-63H.
>>> 
>>>    Somewhere is an I/O port list...I thought Dale Wick had one.  Also
>>> the "ADAM Survival Guide", but mine is a bit buried right now.
>>> 
>>>    *Dr. D.*
>>> 
>> 
>>> --
>>> Richard F. Drushel, Ph.D.            | "They fell:  for Heaven to them no hope
>>> Department of Biology                |  imparts / Who hear not for the beating
>>> Case Western Reserve University      |  of their hearts."
>>> Cleveland, Ohio  44106-7080  U.S.A.  |         -- Edgar Allan Poe, "Al-Aaraaf"
>>> 
>>> 
>>> _______________________________________________
>>> Coladam mailing list
>>> Coladam at adamcon.org
>>> http://adamcon.org/cgi-bin/mailman/listinfo/coladam
>> 
>> 
>> _______________________________________________
>> Coladam mailing list
>> Coladam at adamcon.org
>> http://adamcon.org/cgi-bin/mailman/listinfo/coladam
>> 
>> 



More information about the Coladam mailing list